Day 3

Third day of work. As i downloaded the Cinema 4D program in my laptop, i started of the day designing the 3D models of the prototype, i tried to use some functions which i used in school so that the overall image would look nice. I also added different materials to the 3D image to make it look realistic. These are a few renders of my models.

As the time passes by, I realized that Arduino programming IDE was actually quite simple however to upload it to an RFduino board, it requires a different method. you have to actually power up each GPIO (general purpose input/output) port so that it will be able to configure in the IDE. I started programming for the flex sensors and i built up the individual circuit and somehow the serial monitor of the IDE just do not show me the change in resistance when i flex the sensors. Thus i have to spend the remaining time troubleshooting.